|
Posted by Dean on April 19, 2007, 11:07 am
If you were Registered and logged in, you could reply and use other advanced thread options
started tinkering with the old Murray.After cleaning,checking and a
brief run time the starter went back to just nudging the engine.A
friend stopped in and said to remove the top cover and use a wrench to
roll the engine by hand,,did it and it runs pretty good again.Needs
new gas I'll guess and I have to play with the choke more than last
year till it warms up.
After it died last fall I did nothing with it for storage but there
was no sticky residue in the float bowl so maybe some new gas will get
it back up to snuff,I hate to mess with the carb if it's ok,I prefer
to save that lesson till it's really needed!:-)
I had no gears so looked underneath and the drive belt is broken
and jammed up wich,,I hope,,was the whole prob to begin with.I do'nt
have the #s for the belt so will have to do some research as well as
take what is left of the old belt along to get the correct one first
try.
I guess the Murray seat wo'nt be put on an old canoe after all !
All in all not too bad for an Amateur with a dab of help. I'm learnin.
Dean
| 
XML site map