|
I think a "Dickfore" wrench will work for this nicely.
cavelamb wrote:
> larry wrote:
>
>> "Dan" <B2431@aol.com> wrote in message
>> news:vvAag.29365$fG3.15672@dukeread09...
>>
>>> larry wrote:
>>>
>>>> My maintenance manual describes (what appears to be) a 90º gear drive
>>>> extension. I can't identify it by part number, nor can I seem to
>>>> locate
>>
>>
>> a
>>
>>>> source for purchase.
>>>>
>>>> Details: http://www.turbinefun.com/SpecialTool.asp
>>>>
>>>> Any help you could provide would be greatly appreciated.
>>>>
>>>> Thanks for your help.
>>>> Larry
>>>>
>>>>
>>>
>>> If you can get a torque wrench in where the 90º angle is you won't
>>> need part 4. I've seen the tool to which you refer with a T handle
>>> instead of a socket. Have you tried Sears? I do not recall where I saw
>>> it.
>>>
>>> Dan, U.S. Air Force, retired
>>
>>
>>
>> I tried Sears, and will check with a different Snapon guy. The problem is
>> item 4 is in such a tight spot there's not enough room to swing a
>> handle of
>> any kind.
>>
>> Larry
>>
>>
>
> Sounds like a job for a "crowfoot"?
>
> Richard
|
|
Re: Need help identifying a special tool
