|
"pbc76049" <pbc76049@(removethis)charter.net> wrote
>
> Take a heat gun and warm the plastic locally to about 150ish.
> This will remelt the glue holding the paper to the plastic and
> leave you with squeaky clean plastic to work with. The glue used
> is a low temp thermoset not a solvent based glue so liquids really
> just get in the way and get sucked into the sheet to crreate problems
> later.
> Hope that sounded a bit better......
Much better, no doubt, and thanks for the info. I never had even considered
heat. I just hope this tidbit stays in my forgetful brain, until (not if,
but when) I need to remove some of that hateful old paper again.
--
Jim in NC
|
|
Re: Plexiglass protective paper
