|
Roger, if you're worried about safety and disconnecting air supply in the
event of a hose breakage, I would suggest mounting a solenoid valve at the
compressed air output pipe and wire it to maintained contact palm safety
switches at each exit point. You could even do it using low voltage
thermostat wire by using a small low voltage transformer and a relay. Series
each switch and by slapping any one switch, you break the circuit holding
power to the solenoid, thereby stopping air discharge.
Bill
"Roger (K8RI)" <ValidAddress@my.com> wrote in message
news:4v2ok2dt6i4e5qqp9jvbo3remd273e51kn@4ax.com...
> The subject line pretty much says it.
|
|
Re: Slightly OT: Shop high pressure air manifold.
