|
"Lou" <loupark@hotmail.com> wrote in news:1169120606.808676.277590
@l53g2000cwa.googlegroups.com:
>
> Mine also calls for 1/4" but only from the front spar to
> the back spar, since I've flaps. Laminating 2 peices should
> be ok but I wouldn't us an 1/8" trowel. I'd spred the glue
> around with a popsicle stick or scrap wood, quite a few clamps,
> and straps of wood to put on top. Clamp one end, then start
> clamping every couple of inches until you reach the other end.
OK. Here's what I am thinking now. I use a couple of 3/4 ply ribs as a
mold with holes drilled near the upper edge as a place to locate the
clamps. A few pieces of wood across the underside of the ply to keep it
from sagging and a few pieces clamped right on top of those to ensure a
good contact between the two glued surfaces. the width is only 12 inches
so I am supposing the two pieces would have adequate surface contact
(i.e, no gaps) and I should end up with a molded walkway..
|
|
Re: Wing walk ply question.
