|
Eric Miller wrote:
>> A GE Minigun. :^) Well, it IS a tool...
>>
>
> It dimples at the same time as it drills... 8 holes per sec!
And if you make a mistake while fabricating a part, I cannot think of a
better way of venting frustration.
> If only it shot clecoes and deburred at the same time.
> Finding correct rivets is tough though... and hand squeezing them is out of
> the question :-)
Ah, but the proverbial glass is actually half-full. You could yet
corner a niche market--right now nobody makes 7.62mm rivets or clecoes!
|
|
Re: "Must Have" Tools for Christmas
