|
Just thinking into the future at the moment.
I know nothing about sandblasting except you can apparently use
different abrasive material i.e. glass beads, sand, nut shells (?)
An aircraft I am looking at has some rust at the tail cone. If I
purchase it, I would like to remove the rust and prime it.
Assume my A&P says the tubing is structurally intact, but pits are
evident.
Can someone point me to a reference that talks about what I need to
sandblast the area, what abrasive to use, or if the area is small,
some other method of rust removal? Other considerations?
Sorry, but I know only enough to ask a general question at this point
- Mike
|
|
Sandblasting reference?
